Wednesday, March 7, 2012

Install XenServer 6.0.2 on Dell PowerEdge M710HD using Integrated Remote Access Controller

Installing XenServer is quite simple but option on Dell remote control access controller is little tricky. First we should insure that virtual media is attached by default it will be Detach as shown below.image

Launch the Dell virtual console in order to map the ISO . image

Attach the media virtual media using "Virtual media wizard" as shown belowimage

Browse and assign the media using ISO image image

Change the boot order to boot from the "Virtual CD"image

This will bring the boot menu which will guide step by step to install XenServer 6.0.2

image

Select the Keymap which is mostly US

image

This will bring welcome screen

image

Accept the license agreement .

image

It depends what you want to . We are performing clean installation

image

This will detect the local hard drive where you want to install the XenServer . Choose thin provisioning if you want to enable intellicache for XenDesktop.

image

Installation media will be local media.

image

Supplement packs are required if you are planning to host linux as a guest VM's or else choose NO.

image

If you doubts the install media choose to verify or else skip it.

image

Type the password as Test123  :)

image

Here you are going to choose management interface. This can be bonded once it is added to the pool using XenCenter.

image

Choose the timezone which server belongs to not YOU :)

image

Select the correct country which server is located not YOU :)

image

Define the NTP server which you have or else choose the manual time entry

image

Specify the NTP server name or IP address.

image

Specify the host name and DNS server and continue with XenServer install .

image

You are all set.

1 comment:

Anonymous said...

Has anyone ran 6.0.2 for very long on this blade ?? From what I found out with Dell is it is not on the tested hardware list .. They only certify any blade on 5.6.
Thanks